Boot log for 2.4.16m5 (gubbio)
5 June 2002

Comments:

• This is 2.4.16m5, a particularly successful kernel. Both CD drives work, no error messages except mtrr.
• See also the dmesg from 30 June 2002 and 3 September 2002 (no kernel changes, just a few system changes)
• Note that both CD drives have been switched to scsi emulation -- this is for xcdroast's benefit (see CD-RW)
• The CPU L1 is detected as 16k -- I believe in fact it has 32k?
• I turned off APIC in this kernel -- and now I see that it's APIC that gives you the bus speed figure; cf. dmesg 2.4.16m3.
  The host bus clock is likely only running at 66 -- it should run at 100 (harddrives should be faster).
  You may be able to tweak the new CPU so that it at least uses the full-speed bus!
• pty got included again in this kernel; leaving it out was causing error messages (see kernel)
• You have mtrr v1.40 from 20010327 -- perhaps you should update it? (see mtrr)
• There's a Real Time Clock Driver -- I don't think I'm using it, but I should!
• This kernel has dropped devfs, which I removed from the next version because it appeared to be messing up my already problematic CD situation. However, it's possible that devfs really is a good idea, and you could look into it
• This kernel also dropped the NTFS driver, for Win 2000
• Both tdfxfb and 3Dfx are detected -- and under AGP, I get "[drm] Initialized tdfx 1.0.0 20010216 on minor 0" -- direct rendering? Not sure about the significance of this -- see gubbio configuration
• The ide is running the disks at 33MHz/s bus speed -- override with idebus=xx. See details and solution in gigadrive. This was fixed on 14 June 2002.

Source: /var/log/boot.msg

Inspecting /boot/System.map-2.4.16
Loaded 18888 symbols from /boot/System.map-2.4.16.
Symbols match kernel version 2.4.16.
No module symbols loaded.
klogd 1.4.1, log source = ksyslog started.

Linux version 2.4.16 (root@gubbio) (gcc version 2.95.3 20010315 (SuSE))
#1 Tue Jun 4 17:50:46 PDT 2002

BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000010000000 (usable)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 65536
zone(0): 4096 pages.
zone(1): 61440 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=Linux ro root=1608
BOOT_FILE=/boot/kernel-2.4.16m5 hdb=ide-scsi hdd=ide-scsi vga=0x0317 video=vesa:ywrap 2.4.16m5
ide_setup: hdb=ide-scsi
ide_setup: hdd=ide-scsi
Initializing CPU#0
Detected 801.834 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1599.07 BogoMIPS
Memory: 255128k/262144k available (1586k kernel code, 6628k reserved, 461k data, 220k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel(R) Celeron(TM) CPU 1200MHz stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb3b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'SupraExpress 56i Sp V.90'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
IA-32 Microcode Update Driver: v1.09 <tigran@veritas.com>
Starting kswapd
Journalled Block Device driver loaded
fb: Banshee memory = 16384K
fb: MTRR's turned on
tdfxfb: reserving 1024 bytes for the hwcursor at d17ff000
Console: switching to colour frame buffer device 80x30
fb0: 3Dfx Banshee frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI
ISAPNP enabled
ttyS00 at port 0x03f8 (irq = 4) is a 16550A
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100%% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
PDC20269: IDE controller on PCI bus 00 dev 68
PCI: Found IRQ 7 for device 00:0d.0
PDC20269: chipset revision 2
PDC20269: not 100%% native mode: will probe irqs later
ide2: BM-DMA at 0xbc00-0xbc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xbc08-0xbc0f, BIOS settings: hdg:pio, hdh:pio
hda: Maxtor 91360D8, ATA DISK drive
hdb: CD-ROM 48X/AKU, ATAPI CD/DVD-ROM drive
hdc: Maxtor 51536U3, ATA DISK drive
hdd: CD-RW CRX100E, ATAPI CD/DVD-ROM drive
hde: Maxtor 4G160J8, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xac00-0xac07,0xb002 on irq 7
hda: 26563824 sectors (13601 MB) w/256KiB Cache, CHS=1653/255/63, UDMA(33)
hdc: 30015216 sectors (15368 MB) w/2048KiB Cache, CHS=29777/16/63, UDMA(33)
hde: 320173056 sectors (163929 MB) w/2048KiB Cache, CHS=317632/255/63, UDMA(33)
Partition check:
hda: hda1 hda2 < hda5 >
hdc: [PTBL] [1868/255/63] hdc2 < hdc5 hdc6 hdc7 hdc8 >
hde: hde1
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
natsemi.c:v1.07 1/9/2001 Written by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
(unofficial 2.4.x kernel port, version 1.07+LK1.0.13, Oct 19, 2001 Jeff Garzik, Tjeerd Mulder)
PCI: Found IRQ 10 for device 00:0f.0
eth0: NatSemi DP8381[56] at 0xd2802000, 00:a0:cc:a2:be:83, IRQ 10.
eth0: Transceiver status 0x786d advertising 05e1.
Linux video capture interface: v1.00
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 204M
agpgart: Detected Intel 440BX chipset
agpgart: AGP aperture is 64M @ 0xd0000000
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: E-IDE Model: CD-ROM 48X/AKU Rev: U22
Type: CD-ROM ANSI SCSI revision: 02
Vendor: SONY Model: CD-RW CRX100E Rev: 1.0j
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
Attached scsi CD-ROM sr1 at scsi0, channel 0, id 1, lun 0
sr0: scsi3-mmc drive: 0x/48x xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
sr1: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray
ohci1394: v0.51 08/08/01 Ben Collins <bcollins@debian.org>
PCI: Found IRQ 11 for device 00:11.0
PCI: Sharing IRQ 11 with 00:07.2
ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[db008000-db008800] Max
Packet=[2048]
raw1394: /dev/raw1394 device initialized
Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996
sb: No ISAPnP cards found, trying standard ones...
sb: I/O, IRQ, and DMA are mandatory
Creative EMU10K1 PCI Audio Driver, version 0.16, 17:52:40 Jun 4 2002
PCI: Found IRQ 3 for device 00:0b.0
emu10k1: EMU10K1 rev 5 model 0x20 found, IO at 0xa400-0xa41f, IRQ 3
ac97_codec: AC97 codec, id: 0x5452:0x4123 (TriTech TR A5)
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
ieee1394: Local host added: node 0:1023, GUID 00308d010001a64c
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 11 for device 00:07.2
PCI: Sharing IRQ 11 with 00:11.0
uhci.c: USB UHCI at I/O 0xa000, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver usbscanner
scanner.c: 0.4.6:USB Scanner Driver
usb.c: registered new driver usblp
printer.c: v0.8:USB Printer Device Class driver
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
ip_conntrack (2048 buckets, 16384 max)
ip_tables: (c)2000 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 220k freed
Adding Swap: 787144k swap-space (priority 42)
Kernel logging (ksyslog) stopped.