Boot log for 2.3.16m3 (mutt)

Boot log for 2.4.16m3 (gubbio)
30 May 2002

Comments:

This is a short-lived kernel on the way to 2.4.16m5, a particularly successful kernel
Note that the host bus clock is only running at 66 -- it should run at 100 (harddrives should be faster).
You may be able to tweak the new CPU so that it at least uses the full-speed bus!
This kernel still has devfs, which I removed from the next version because it appeared to be messing up
my already problematic CD situation. However, it's possible that devfs really is a good idea, and you
could look into it
This kernel also has the NTFS driver, for Win 2000 -- I removed it from m5.
Both tdfxfb and 3Dfx are detected -- not sure about the significance of this
The ide is running the disks at 33MHz/s bus speed -- override with idebus=xx. Not sure what to do here --
what the restrictions are and how I make that setting.
Under AGP, I get "[drm] Initialized tdfx 1.0.0 20010216 on minor 0" -- direct rendering?
The CD-RW gets detected as a SCSI device, but not assigned a scsi node, presumably because some
scsi component was not yet included in the kernel. This was fixed in m4; then m5 switched both CD drives
to scsi emulation.
I still had ipv6 in this kernel, later dropped

Linux version 2.4.16 (root@gubbio) (gcc version 2.95.3 20010315 (SuSE)) #1 Thu May
30 00:22:25 PDT 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000010000000 (usable)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 65536
zone(0): 4096 pages.
zone(1): 61440 pages.
zone(2): 0 pages.
Local APIC disabled by BIOS -- reenabling.
Found and enabled local APIC!
Kernel command line: auto BOOT_IMAGE=Linux ro root=1607
BOOT_FILE=/boot/kernel-2.4.16m3 hdd=ide-scsi vga=0x0317 video=vesa:ywrap 2.4.16m3
ide_setup: hdd=ide-scsi
Initializing CPU#0
Detected 801.826 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1599.07 BogoMIPS
Memory: 254824k/262144k available (1775k kernel code, 6932k reserved, 532k data, 260k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383fbff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383fbff 00000000 00000000 00000000
CPU: After generic, caps: 0383fbff 00000000 00000000 00000000
CPU: Common caps: 0383fbff 00000000 00000000 00000000
CPU: Intel(R) Celeron(TM) CPU 1200MHz stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
enabled ExtINT on CPU#0
ESR value before enabling vector: 00000040
ESR value after enabling vector: 00000000
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 801.8338 MHz.
..... host bus clock speed is 66.8193 MHz
cpu: 0, clocks: 668193, slice: 334096
CPU0<T0:668192,T1:334096,D:0,S:334096,C:668193>
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb3b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'SupraExpress 56i Sp V.90'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
Journalled Block Device driver loaded
devfs: v0.120 (20011103) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
NTFS driver v1.1.20 [Flags: R/O]
fb: Banshee memory = 16384K
fb: MTRR's turned on
tdfxfb: reserving 1024 bytes for the hwcursor at d17ff000
Console: switching to colour frame buffer device 80x30
fb0: 3Dfx Banshee frame buffer device
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI
ISAPNP enabled
ttyS00 at port 0x03f8 (irq = 4) is a 16550A
Real Time Clock Driver v1.10e
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
PDC20269: IDE controller on PCI bus 00 dev 68
PCI: Found IRQ 7 for device 00:0d.0
PDC20269: chipset revision 2
PDC20269: not 100% native mode: will probe irqs later
ide2: BM-DMA at 0xbc00-0xbc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xbc08-0xbc0f, BIOS settings: hdg:pio, hdh:pio
hda: Maxtor 91360D8, ATA DISK drive
hdb: CD-ROM 48X/AKU, ATAPI CD/DVD-ROM drive
hdc: Maxtor 51536U3, ATA DISK drive
hdd: CD-RW CRX100E, ATAPI CD/DVD-ROM drive
hde: Maxtor 4G160J8, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xac00-0xac07,0xb002 on irq 7
hda: 26563824 sectors (13601 MB) w/256KiB Cache, CHS=1653/255/63, UDMA(33)
hdc: 30015216 sectors (15368 MB) w/2048KiB Cache, CHS=29777/16/63, UDMA(33)
hde: 320173056 sectors (163929 MB) w/2048KiB Cache, CHS=317632/255/63, UDMA(33)
hdb: ATAPI 48X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
/dev/ide/host0/bus0/target0/lun0: p1 p2 < p5 >
/dev/ide/host0/bus1/target0/lun0: [PTBL] [1868/255/63] p2 < p5 p6 p7 p8 >
/dev/ide/host2/bus0/target0/lun0: p1
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
natsemi.c:v1.07 1/9/2001 Written by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
(unofficial 2.4.x kernel port, version 1.07+LK1.0.13, Oct 19, 2001 Jeff Garzik, Tjeerd Mulder)
PCI: Found IRQ 10 for device 00:0f.0
eth0: NatSemi DP8381[56] at 0xd2806000, 00:a0:cc:a2:be:83, IRQ 10.
eth0: Transceiver status 0x786d advertising 05e1.
Linux video capture interface: v1.00
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 204M
agpgart: Detected Intel 440BX chipset
agpgart: AGP aperture is 64M @ 0xd0000000
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: SONY Model: CD-RW CRX100E Rev: 1.0j
Type: CD-ROM ANSI SCSI revision: 02
ohci1394: v0.51 08/08/01 Ben Collins <bcollins@debian.org>
PCI: Found IRQ 11 for device 00:11.0
PCI: Sharing IRQ 11 with 00:07.2
ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[db008000-db008800] Max Packet=[2048]
raw1394: /dev/raw1394 device initialized
ieee1394: sbp2: Driver forced to serialize I/O (serialize_io = 1)
scsi1 : IEEE-1394 SBP-2 protocol driver
Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996
sb: No ISAPnP cards found, trying standard ones...
sb: I/O, IRQ, and DMA are mandatory
Creative EMU10K1 PCI Audio Driver, version 0.16, 00:24:21 May 30 2002
PCI: Found IRQ 3 for device 00:0b.0
emu10k1: EMU10K1 rev 5 model 0x20 found, IO at 0xa400-0xa41f, IRQ 3
ac97_codec: AC97 codec, id: 0x5452:0x4123 (TriTech TR A5)
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
ieee1394: Local host added: node 0:1023, GUID 00308d010001a64c
uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 11 for device 00:07.2
PCI: Sharing IRQ 11 with 00:11.0
uhci.c: USB UHCI at I/O 0xa000, IRQ 11
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb.c: registered new driver usbscanner
scanner.c: 0.4.6:USB Scanner Driver
usb.c: registered new driver usblp
printer.c: v0.8:USB Printer Device Class driver
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
ip_conntrack (2048 buckets, 16384 max)
ip_tables: (c)2000 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 260k freed
i2c-core.o: i2c core module version 2.6.4-CVS (2002xxx)
i2c-isa.o version 2.6.3 (20020322)
i2c-isa.o: ISA bus access for i2c modules initialized.
i2c-proc.o version 2.6.4-CVS (2002xxx)
lm78.o version 2.6.3 (20020322)
Adding Swap: 787144k swap-space (priority 42)
eth0: link is back. Enabling watchdog.
eth0: Setting full-duplex based on negotiated link capability.
eth0: no IPv6 routers present

Maintained by Francis F. Steen, Communication Studies, University of California Los Angeles