dmesg for gubbio
kernel 2.4.16p
24 May 2002

/var/log/boot.msg
Inspecting /boot/System.map-2.4.16
Loaded 15417 symbols from /boot/System.map-2.4.16.
Symbols match kernel version 2.4.16.
No module symbols loaded - kernel modules not enabled.

klogd 1.4.1, log source = ksyslog started.
Linux version 2.4.16 (root@gubbio) (gcc version 2.95.3 20010315 (SuSE)) #4 Sun Dec 30 04:19:32 PST 2001
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000010000000 (usable)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 65536
zone(0): 4096 pages.
zone(1): 61440 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=Linux ro root=1607 BOOT_FILE=/boot/kernel-2.4.16p enableapic vga=0x0314 hdd=ide-scsi 2 4 16
ide_setup: hdd=ide-scsi
Initializing CPU#0
Detected 801.836 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1599.07 BogoMIPS
Memory: 255328k/262144k available (1481k kernel code, 6428k reserved, 377k data, 216k init, 0k highmem)
Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 5, 131072 bytes)
Mount-cache hash table entries: 4096 (order: 3, 32768 bytes)
Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)
Page-cache hash table entries: 65536 (order: 6, 262144 bytes)
CPU: Before vendor init, caps: 0383f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0383f9ff 00000000 00000000 00000000
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel(R) Celeron(TM) CPU 1200MHz stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfb3b0, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: Card 'SupraExpress 56i Sp V.90'
isapnp: 1 Plug & Play card detected total
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
IA-32 Microcode Update Driver: v1.09 <tigran@veritas.com>
Starting kswapd
Journalled Block Device driver loaded
<3>ACPI: System description tables not found
ACPI-0068: *** Error: Acpi_load_tables: Could not get RSDP, AE_ERROR
ACPI-0116: *** Error: Acpi_load_tables: Could not load tables: AE_ERROR
<3>ACPI: System description table load failed
fb: Banshee memory = 16384K
fb: MTRR's turned on
tdfxfb: reserving 1024 bytes for the hwcursor at d17ff000
Console: switching to colour frame buffer device 80x30
fb0: 3Dfx Banshee frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at port 0x03f8 (irq = 4) is a 16550A
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100%% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA
PDC20269: IDE controller on PCI bus 00 dev 68
PCI: Found IRQ 7 for device 00:0d.0
PDC20269: chipset revision 2
PDC20269: not 100%% native mode: will probe irqs later
ide2: BM-DMA at 0xbc00-0xbc07, BIOS settings: hde:pio, hdf:pio
ide3: BM-DMA at 0xbc08-0xbc0f, BIOS settings: hdg:pio, hdh:pio
hda: Maxtor 91360D8, ATA DISK drive
hdb: CD-ROM 48X/AKU, ATAPI CD/DVD-ROM drive
hdc: Maxtor 51536U3, ATA DISK drive
hdd: CD-RW CRX100E, ATAPI CD/DVD-ROM drive
hde: Maxtor 4G160J8, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide2 at 0xac00-0xac07,0xb002 on irq 7
hda: 26563824 sectors (13601 MB) w/256KiB Cache, CHS=1653/255/63, UDMA(33)
hdc: 30015216 sectors (15368 MB) w/2048KiB Cache, CHS=29777/16/63, UDMA(33)
hde: 320173056 sectors (163929 MB) w/2048KiB Cache, CHS=317632/255/63, UDMA(33)
hdb: ATAPI 48X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2 < hda5 >
hdc: [PTBL] [1868/255/63] hdc2 < hdc5 hdc6 hdc7 hdc8 >
hde: hde1
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
natsemi.c:v1.07 1/9/2001 Written by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
(unofficial 2.4.x kernel port, version 1.07+LK1.0.13, Oct 19, 2001 Jeff Garzik, Tjeerd Mulder)
PCI: Found IRQ 10 for device 00:0f.0
eth0: NatSemi DP8381[56] at 0xd2802000, 00:a0:cc:a2:be:83, IRQ 10.
eth0: Transceiver status 0x7869 advertising 05e1.
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 204M
agpgart: Detected Intel 440BX chipset
agpgart: AGP aperture is 64M @ 0xd0000000
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: SONY Model: CD-RW CRX100E Rev: 1.0j
Type: CD-ROM ANSI SCSI revision: 02
ohci1394: v0.51 08/08/01 Ben Collins <bcollins@debian.org>
PCI: Found IRQ 11 for device 00:11.0
PCI: Sharing IRQ 11 with 00:07.2
ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[db008000-db008800] Max Packet=[2048]
raw1394: /dev/raw1394 device initialized
Creative EMU10K1 PCI Audio Driver, version 0.16, 04:12:34 Dec 30 2001
PCI: Found IRQ 3 for device 00:0b.0
emu10k1: EMU10K1 rev 5 model 0x20 found, IO at 0xa400-0xa41f, IRQ 3
ac97_codec: AC97 codec, id: 0x5452:0x4123 (TriTech TR A5)
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
ieee1394: Local host added: node 0:1023, GUID 00308d010001a64c
usb-uhci.c: $Revision: 1.268 $ time 04:12:58 Dec 30 2001
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 11 for device 00:07.2
PCI: Sharing IRQ 11 with 00:11.0
usb-uhci.c: USB UHCI at I/O 0xa000, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.268:USB Universal Host Controller Interface driver
usb.c: registered new driver hid
hid-core.c: v1.8 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
usb.c: registered new driver usbscanner
scanner.c: 0.4.6:USB Scanner Driver
usb.c: registered new driver usblp
printer.c: v0.8:USB Printer Device Class driver
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Linux IPX 0.47 for NET4.0
IPX Portions Copyright (c) 1995 Caldera, Inc.
IPX Portions Copyright (c) 2000, 2001 Conectiva, Inc.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 216k freed
Adding Swap: 787144k swap-space (priority 42)
Kernel logging (ksyslog) stopped.
Kernel log daemon terminating.
/var/log/boot.msg lines 111-159/159 (END)